Back again for some help......
Thread Starter
|
Elder User
Joined: Jan 2005
Posts: 908
Likes: 0
From: Lindsborg, KS
Back again for some help......
I have a few questions concerning my engine swap. I am swapping in a Mercruiser 302 with a M5OD transmission. Has anyone ever done this swap? How far back does the shifter sit? Will i have to notch my seat to use this set up? How hard is it to drill the holes in the frame for the engine mounts? How hard is it to make the transmission mount crossmember? Any useful advice on making this engine swap go faster and easier?
Thanks
Dustin
Thanks
Dustin
Lead Driver
Joined: Apr 2002
Posts: 8,813
Likes: 13
From: Littleton, New Hampshire
I don't know much about this swap but it seems to me that there should be engine and transmission mount kits available for it or if not, some type of universal mounts. Check out Speedway Motors, Sacramento Ford, and other street rod parts manufacturers. There should be something out there to help you... 
Vern
Vern
Moderator
Joined: Dec 2003
Posts: 97,596
Likes: 2,008
From: Saskatoon, Saskatchewan
Check the older posts in this thread as it is a common swap and there should be lots of info. FTE engine swap forums will be useful.
Last edited by Fomoko1; Jan 15, 2006 at 11:01 AM.
Cargo Master
Joined: May 2003
Posts: 2,561
Likes: 1
From: Earth
From my personnal experience, I gotta say that measurements are fine and all....BUT, the best method is to just use an engine hoist and mock-up where the engine and tranny should be in the engine bay. All I did was to make sure that the cab is on the frame, and go from there. I didn't use your combo, but the same method would apply.
