Rear seats In cargo Van?
#1
#2
#3
Yes thats what i thought, like steel posts the seat locks on to. There were a couple of bench seats that looked like they just bolted to the floor, on mine there is Nothing doing there no holes nothing. I bought it for my magazine route looks like it will be used only for that. thanks for reply
#4
#5
I was going to say the more critical one would be for the rear bench, since that can interfere with the wheel wells. On my van, the two sets of anchor wells are lined up, so that you can move either bench straight forward or back. The only peculiarity I found was that when I installed a set of seat-beds I got from a scrap yard, they have a 2" gap between them when folded down. This tells me that there may be some variation in fore-aft spacing between the wells. The seat-beds came out of a shorty, and mine is an extended van, so maybe they put the rear bench a couple inches further back.
Thread
Thread Starter
Forum
Replies
Last Post
CraigH-CA
1968-Present E-Series Van/Cutaway/Chassis
15
08-29-2011 06:00 PM
goodwrench
1968-Present E-Series Van/Cutaway/Chassis
6
05-05-2010 07:50 AM