m-block header question
Thread Starter
|
Posting Guru
Joined: Mar 2009
Posts: 1,357
Likes: 1
From: Alston, MI
m-block header question
i was looking at some full length headers for my 77 f150 4x4. now, these look like theyd be a b*tch to put on w/the clutch linkage in the way. they look like theyd be hard to put on even w/a c6. i heard starters would be hard to change, but im more worried about the clutch linkage. soo, yea, would they fit w/o problems?
Senior User
Joined: Jul 2005
Posts: 494
Likes: 0
From: Mountville PA
I have a 78 f150 with a c6 I have hooker headers that come down on the inside of the drive shaft on the driver side I also have a 79 bronco also c6 with dynomax headers that come down on the outside of the driveshaft some manufactures do one some do the other I have no problem changing the starter it is hard to see the top bolt but not a big problem I know what the clutch linkage looks like and I dont think it will get in the way with the inside the drive shaft headers (hookers) the dynomax headers have the exhaust going down the driver side of the frame and it goes right through where the clutch linkage would be hope this gives you a little bit of help.
