serpentine conversion...help!
Thread Starter
|
New User
Joined: Jan 2007
Posts: 8
Likes: 0
serpentine conversion...help!
hey guys, i am in the finishing stages of building a 2 seater rock racer for this xrra season. it is a mid engine- 95' ford 5.0l 302 from a bronco. my problem is i have a rolling chassis ready to go but cannot seem to find a serpentine conversion for this motor that will eleminate the a/c ,smog etc. i need one that will run water/saginaw type p.steering/alt. anyone out there that can help me with this? thanks in advance...
Thread Starter
|
New User
Joined: Jan 2007
Posts: 8
Likes: 0
Originally Posted by 75F350
I would imagine March should have the kit you are looking for, heak they make just about everything. Looks like it is the performance ratio, ultra kit, with the power steering option.
Lead Driver
Joined: May 2000
Posts: 9,236
Likes: 12
From: Senoia, GA
so you are looking for the 6-groove serp pulleys for your WP, sag pump, and alt?
if you get the pulleys digging through AutoZoo's inventory for the right length belt. you have an idler pulley?
EDIT.... jeff's bronco graveyard has a decent selection of pulley's and a couple of systems
-cutts-
if you get the pulleys digging through AutoZoo's inventory for the right length belt. you have an idler pulley?
EDIT.... jeff's bronco graveyard has a decent selection of pulley's and a couple of systems
-cutts-
Last edited by fishmanndotcom; Jan 31, 2007 at 10:38 PM.
