1958 F-100 Parts FREE for a Good Home
For SaleExterior Body Parts
04-23-2018, 08:42 AM | Replies: 5 | Views: 1136
Description:
Since I completed restoring my truck (almost 5 yrs ago now), I am looking to purge all extra parts that I have left over. I have a car that will be going to the junk yard sometime over the summer and what ever parts I have left from the truck at that time they will be going with the car. I am just hoping that there is someone out there that is able to use these parts.
The parts listed below are FREE for a good home (buyer pays shipping on smaller parts), I have more stuff just ask if what you need is not listed below. I can help deliver parts anywhere between Winona MN and Hudson WI. PLEASE CONTACT ONLY IF INTERESTED I CAN SEND PICS UPON REQUEST.
- 57-58 LH/RH front fenders (round turn signal)
- 57-60 LH/RH front inner fenders
- 57-58 (1) front valance (round turn signal)
- (1) Bare Cab Weld, Roof is only part intact. (floor badly rusted and cut, dash is cut etc)
- (1) 57-58 Hood, front brow is cut off for a patch panel for my hood
- (1) 57-60 Gas Tank
- (3) Cowl rain guards (piece below windshield and behind hood on cab weld)
- (1) Defroster dash trim piece
- (1) Door access panel cover
- (1) Radiator fan shroud (6 cyl radiator)
- (1) Radiator Support (badly rusted)
- I also have more MISC random piece parts available for 57-60 F-100's
- I have a 5 gallon bucket of parts for a 239cid Ford Y-Block (motor mounts (sedan), fan, pulley, ect.)
#2
Parts inquiry
Checking to see if you still have any of these body parts? Would you have a pic of the top side of the valance? I'm a little over an hour south of Winona. Also, do you have a pic of the back of cab and the dash?
#3
Hi Thank you for the reply. Unfortunately from what is shown in the pics the cab, hood, fenders, and front valance have all gone to a new home. A few of the other items not listed below were sold at Back to the 50's swap meet. I do however still have the following:
- 57-60 LH/RH front inner fenders
- (1) 57-60 Gas Tank
- (3) Cowl rain guards (piece below windshield and behind hood on cab weld)
- (1) Defroster dash trim piece
- (1) Radiator Support (badly rusted)
- Heater blower w/ heater core
- Y-Block intake manifold
- Y-Block stock valve covers
- Bell housing for Y-Block 3 speed transmission
- And maybe a few other things I can't think off. Reply with detailed list and I will get back to you ASAP.
#6
Sawmaned might have to take you up on that. Was just contacting F-100Custom 1st since he was within driving distance. Haven't done anything with pics on here for quite a while so not sure what's allowed. Could email you too if that works. At least I could show you which dash area and get you address to check shipping prices