JUNE to DECEMBER CHAT-2012
#1728
#1729
#1730
I am down to the little things, run new brake lines down to the porp valve, make some transmission lines, make a fuel line from the pump to the carb, measure for the drive shaft and have it cut down, find a place to make me a speedo cable, Wiring to run and hook up, decide if i want a new radiator or not... put the front clip on.
#1731
Join Date: Mar 2009
Location: North Bay Ont Canada
Posts: 161,189
Received 5,363 Likes
on
1,731 Posts
#1733
Join Date: Mar 2009
Location: North Bay Ont Canada
Posts: 161,189
Received 5,363 Likes
on
1,731 Posts
#1735
Hi all.
Productive weekend here. Found a hoist and 1500# stand on CL Friday night Bought 'em Saturday morning. Got motor out of my p'up. It's an oily mess...
Went to mount up to the stand and the arms arent wide enough for this motor!! I can mount the top two arms but lack 5/8" of spread to mount bottom two arms...
So I am stuck with the engine on the floor and no real way to work on it....
I guess I can squat down and start scrubbing oily goop off it while I evolve a solution...
Productive weekend here. Found a hoist and 1500# stand on CL Friday night Bought 'em Saturday morning. Got motor out of my p'up. It's an oily mess...
Went to mount up to the stand and the arms arent wide enough for this motor!! I can mount the top two arms but lack 5/8" of spread to mount bottom two arms...
So I am stuck with the engine on the floor and no real way to work on it....
I guess I can squat down and start scrubbing oily goop off it while I evolve a solution...
#1737
Hi all.
Productive weekend here. Found a hoist and 1500# stand on CL Friday night Bought 'em Saturday morning. Got motor out of my p'up. It's an oily mess...
Went to mount up to the stand and the arms arent wide enough for this motor!! I can mount the top two arms but lack 5/8" of spread to mount bottom two arms...
So I am stuck with the engine on the floor and no real way to work on it....
I guess I can squat down and start scrubbing oily goop off it while I evolve a solution...
Productive weekend here. Found a hoist and 1500# stand on CL Friday night Bought 'em Saturday morning. Got motor out of my p'up. It's an oily mess...
Went to mount up to the stand and the arms arent wide enough for this motor!! I can mount the top two arms but lack 5/8" of spread to mount bottom two arms...
So I am stuck with the engine on the floor and no real way to work on it....
I guess I can squat down and start scrubbing oily goop off it while I evolve a solution...
#1738