Hey guys, my truck has had an issue lately going into limp mode. Truck loses power, wrench light comes on dash panel, place in park, turn it off, set a minute, and start it back up. It does good for some time. What could this be?

 

When is the last time the fuel filter was changed?

 

The error code given was the driveshaft speed sensor error. Has anyone experienced this?

 

If that sensor isn't sending a signal the ECM doesn't know the vehicle is moving and figures no additional engine power is needed.

 

Do you know what to do or how to fix this issue? Thanks

 

The simplest answer is to crawl under the vehicle and change the sensor.