Technical Service Bulletins
|Publication Date: APRIL 26, 1999|
|1999 F-150, F-250 LD|
The storage bin inside the console may fall down inside the console base on some vehicles. This may be caused by the box warping and not fitting properly on the lip of the base.
Drill a hole and add two (2) rubber bumpers for spacers. The spacers will increase the surface contact area and reduce the possibility of the bin falling. Refer to the following Service Procedure for details.
- Drill two (2) 3mm (1/8″) diameter holes through the upper left side wall approximately 25mm (1″) from each end (Figure 1).
- Insert two (2) small, conical head Bumpers (N805844-S) into the drilled holes from the outside.
- Cut off the bumper tails on the inside of the bin.
|PART NUMBER||PART NAME|
OTHER APPLICABLE ARTICLES:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
|990812A||Install Bumpers||0.3 Hr.|
|BASIC PART NO.||CONDITION CODE|
Figure 1 – Article 99-8-12
Copyright © 1999 Ford Motor Company