Technical Service Bulletins
|Publication Date: OCTOBER 7, 1996|
|1992-1996 AEROSTAR, BRONCO, ECONOLINE, F-150-350 SERIES|
The speedometer needle may waver and/or a light surge may occur on some vehicles when speed control is used at highway speeds between 80-113 km/h (50-70 mph). This may be due to slight dents/chips in either the exciter ring or the Vehicle Speed Sensor (VSS) and air gaps between the VSS and the exciter ring.
Replace the Programmable Speedometer/Odometer Module (PSOM) if required. New PSOM’s come with increased immunity to system variability. Refer to the following Diagnostic Procedure for details.
BRONCO/F-SERIES – Perform normal PSOM diagnostics per Pinpoint Tests “H” and “J” of the 1996 F-Series/Bronco Body/Chassis Service Manual, Pages 13-01-30 through 13-01-32 and Pinpoint “B” of the 1996 Powertrain/Drivetrain Service Manual, Page 10-03-11.
ECONOLINE – Perform normal PSOM diagnostics per Pinpoint Tests “H” and “J” of the 1996 Econoline Body/Chassis Service Manual, Pages 13-01-29 through 13-01-31 and Pinpoint “B” of the 1996 Powertrain/Drivetrain Service Manual, Page 10-03-9.
AEROSTAR – Perform normal PSOM diagnostics per Pinpoint Test “K” of the 1994 Aerostar Body/Chassis Service Manual, Page 13-01B-31.
- Any slight dents, chips, etc., in either the exciter ring or VSS will create needle waver. Measure air gap between the VSS and exciter ring. It should be 0.38-0.51mm (0.015-0.020″).
- Check exciter ring runout per the same ring gear backface runout procedure of the appropriate model 1996 Powertrain/Drivetrain Service Manual, Section 05-00. Make sure the exciter ring is mounted correctly to the ring gear. If runout is more than 0.1mm (0.004″), perform the differential runout check per the procedure in the appropriate model 1996 Powertrain/Drivetrain Service Manual, Section 05-02A or 05-02D, to find cause and repair as needed.
- If all items listed above check good, replace the Instrument Cluster Assembly. Obtain the correct service part number from the Parts Catalogue and then contact the Electronic Odometer Exchange Center at (800) 259-9700 for U.S. Dealers and (800) 663-9974 for Canadian Dealers.
NOTE: DEALERSHIP MUST TELL THE ODOMETER EXCHANGE CENTER THAT YOU NEED A PSOM3 LEVEL CLUSTER FOR A SPEEDOMETER NEEDLE WAVER CONCERN.
OTHER APPLICABLE ARTICLES:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
|962111A||Replace Programmable Speedometer/Odometer Module (PSOM) – F-Series, Bronco||0.6 Hr.|
|962111B||Replace Programmable Speedometer/Odometer Module (PSOM) – Econoline||0.7 Hr.|
|962111C||Replace Programmable Speedometer/Odometer Module (PSOM) – Aerostar||0.8 Hr.|
|BASIC PART NO.||CONDITION CODE|
204000, 204100, 204200, 205000