Technical Service Bulletins
|Publication Date: November 21, 2007|
|2007-2008 Mark LT|
Some 2007-2008 F-150 and Mark LT vehicles equipped with a 5.4L engine only, may exhibit a rough running, hesitation and/or induction backfire during the first drive away event following an overnight or extended soak. No diagnostic trouble codes (DTCs) or other driveability concerns should be observed. This typically occurs when the ambient temperature is below 60 degrees F (16 degrees C). The event will last only 20-40 seconds and normal operation will return once the system enters closed loop. This TSB only applies to:
- F-150 and Mark LT vehicles built between 12/4/2006 and 10/25/2007 at the Dearborn Truck Plant.
- F-150 vehicles built between 12/4/2006 and 10/29/2007 at the Kansas City Assembly Plant.
- F-150 vehicles built after 12/4/2006 at the Norfolk Assembly Plant.
Follow the Service Procedure steps to correct the condition.
|NOTE:||IF OTHER DRIVEABILITY CONCERNS ARE PRESENT OR NOTED BY THE CUSTOMER, DO NOT CONTINUE WITH THIS TSB. FOLLOW NORMAL WORKSHOP MANUAL (WSM) DIAGNOSTICS.|
|NOTE:||NO DTC'S WILL BE PRESENT WITH THE CONDITION THIS CALIBRATION IS DESIGNED TO ADDRESS. IF DTC'S ARE PRESENT DO NOT CONTINUE WITH THIS TSB. FOLLOW NORMAL WSM DIAGNOSTICS.|
Reprogram the powertrain control module (PCM) to the latest calibration using IDS release 51.5 and higher. Calibration files may also be obtained at www.motorcraft.com.
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
|072403A||2007-2008 F-150, Mark LT 5.4L: Check DTCs And Reprogram The PCM (Do Not Use With 12650D)||0.4 Hr.|
|BASIC PART NO.||CONDITION CODE|