Technical Service Bulletins
|Publication Date: October 7, 2003|
|2000 ECONOLINE, EXCURSION, SUPER DUTY F SERIES|
Article 99-25-10 is being republished in its entirety as part of a consolidated 7.3L diagnostic aid booklet.
California emissions vehicles built after 10/24/1999 have a new Glow Plug Monitor system which incorporates a solid state Glow Plug Control Module (GPCM). This system replaces the relay and shunt assembly previously used.
Refer to the following Diagnostic Procedure for new GPCM system pinpoint test.
The GPCM supplies power to the glow plugs through solid state drivers and performs diagnostics internally to detect and report system failures. The Powertrain Control Module (PCM) still controls glow plug on-time through a control circuit between the two modules. On-time is a function of engine oil temperature, barometric pressure, and battery voltage. This is the same as the previous system.
There are two circuits connecting the PCM and the GPCM. PCM Pin 101 is still used as the control circuit which activates the GPCM to enable glow plugs. PCM Pin 8 is used as the serial communication circuit which is used for the GPCM to report failures to the PCM. The PCM monitors these circuits for failures. The GPCM internally performs diagnostics for individual glow plug/glow plug circuit failures. When a failure is detected, the GPCM will transmit that failure to the PCM over the communication circuit. If a fault is detected, it will be stored in PCM continuous memory. New fault codes have been added and descriptions are as follows:
- P0670 – Glow plug (GP) control circuit malfunction
- P0671 – Glow plug #1 circuit failure (circuit/GP)
- P0672 – Glow plug #2 circuit failure (circuit/GP)
- P0673 – Glow plug #3 circuit failure (circuit/GP)
- P0674 – Glow plug #4 circuit failure (circuit/GP)
- P0675 – Glow plug #5 circuit failure (circuit/GP)
- P0676 – Glow plug #6 circuit failure (circuit/GP)
- P0677 – Glow plug #7 circuit failure (circuit/GP)
- P0678 – Glow plug #8 circuit failure (circuit/GP)
- P0683 – Glow plug diagnostic signal communication fault
When servicing this system for fault codes, carefully inspect all connections for damaged or pushed out pins and fully engaged connectors. The green engine harness connector must be connected to the green glow plug monitor connector and the black engine harness connector must be connected to the black glow plug monitor connector. After any repair or removal of the GPCM components, it is very important to re-run the KOER Glow Plug Monitor self test to verify no system faults are present before releasing the vehicle. For diagnostic procedures, refer to the new pinpoint test for the GPCM system (Figures 1-6).
|NOTE:||WHEN SERVICING OR DIAGNOSING THE GLOW PLUG SYSTEM OR WHEN DISCONNECTING THE GREEN AND BLACK CONNECTORS ON THE GPCM, UNBOLT THE MODULE FROM THE MOUNTING BRACKET FIRST AND THEN DISCONNECT THE GPCM GREEN AND BLACK CONNECTORS. THIS WILL ALLOW FOR EASIER DISCONNECT AND WILL HELP PREVENT DAMAGE TO THE CONNECTOR TERMINALS DURING DISASSEMBLY/ASSEMBLY.|
OTHER APPLICABLE ARTICLES:
Figure 1 – Article 03-21-36
Figure 2 – Article 03-21-36
Figure 3 – Article 03-21-36
Figure 4 – Article 03-21-36
Figure 5 – Article 03-21-36
Figure 6 – Article 03-21-36