Hey guys, Ive converted auto to standard before, but never on a ford truck.
So here's the specs:
1995 F150, 2WD, Short Bed, 302 engine
I need to know if anyone has done this with a late 90's F150, because Im not sure if there's a difference in the auto drive shaft, and manual drive shaft.
This is what I think I need for the swap:
- Manual Tranny
- Clutch Pedal assembly
- Manual brake pedal assembly
- Clutch Master Cylinder
- (Possible) Manual Drive Shaft?
Please let me know what problems/ little quarks you ran into while doing this conversion, and if the drive shafts are different.
Thanks guys,
NashT