It is pretty high for a 2wd.
Installation- Position the brake disc on the spindle.
- NOTE: Tighten the spindle nut to the specified torque. Rotate the disc counterclockwise 5 rotations and then recheck the torque.
Install a new spindle nut.- Tighten to 400 Nm (295 lb-ft).
- Install the spindle nut retainer and a new cotter pin.
- Position the brake caliper and anchor plate assembly and install 2 new bolts.
- Tighten to 200 Nm (148 lb-ft).
- Install the wheel and tire. For additional information, refer to Section 204-04.