Originally Posted by mc320
I got a code that says the rear wheel speed sensor is bad and I see that several of you on this thread have replaced it. Would someone walk me thru the steps to 1) get to it and 2) replace it? I am now trying to go at it from the rear by removing the spare tire and the plastic moldings that surround the spare tire. Am I on the right track? Can you post some pics?
mc320, it's much easier to go at it from the driver's side. Just jack it up and put jackstands under that side, enough to allow you to crawl under it. You can reach up and remove one bolt, maybe an 8mm or so, then pull the sensor directly out. There's one electrical plug-in for it.
It's easy to do, but the sensor is up where it's hard to access. You'll have to go by 'feel' to loosen and tighten the hold down bolt, but it's about a 15 minute job.