302 EFI Roller Rockers / Valve Cover Clearance
[updated:LAST EDITED ON 29-May-02 AT 02:42 AM (EST)]>Your replies are appreciated! lvstang..... so, if I
>understand this correctly, I should be able to run
>pedestal-mount type roller rockers under the stock valve
>covers if I remove or modify the baffles? I'm not terribly
>concerned with hood clearance, as the application is an '85
>Bronco, so I'm guessing that my other option would be the
>FRPP covers and spacer.
You're welcome.
14trax used the magnums which I believe have the stamped body with the roller tip. The Crane(Cobra) 1.7 rollers have the bigger aluminum body. I personally dig both the FRPP E-302 valve covers (too tall without the intake spacer) and the '83 finned "powered by Ford" covers which I had polished and cut out the baffles. I also sorta like the stepped aluminum cover that came on late '80's early 90's HO 5.0's. same baffles as the '83 covers.
You can drill any cover for PCV etc.