<TABLE cellSpacing=0 borderColorDark=#000000 cellPadding=0 borderColorLight=#000000 border=1><TBODY><TR><TD vAlign=top width=395>The engine does not start and LED remains off. <!--mstheme--></TD><TD vAlign=top width=504><!--mstheme-->1. Check PATS system fuses 2. If alarm is fitted check if LED functions for alarm: if not check cigar lighter fuse (also used for LED)
3. If not go to main dealer <!--mstheme-->
</TD></TR><TR><TD vAlign=top width=395><!--mstheme-->Engine does not start: LED flashes rapidly <!--mstheme--></TD><TD vAlign=top width=504><!--mstheme-->Leave ignition on until the LED starts to flash a 2 digit code: (sequence- pause-sequence) Check the following codes: <!--mstheme-->
</TD></TR><TR><TD vAlign=top width=395><!--mstheme-->Code flashes: <!--mstheme--></TD><TD vAlign=top width=504><!--mstheme--><!--mstheme--></TD></TR><TR><TD vAlign=top width=395><!--mstheme-->1:3 <!--mstheme--></TD><TD vAlign=top width=504><!--mstheme-->Key code not received. Is key screened by other keys or objects? Try different key: if okay then first key is faulty. If not go to main dealer <!--mstheme-->
</TD></TR><TR><TD vAlign=top width=395><!--mstheme-->1:4 <!--mstheme--></TD><TD vAlign=top width=504><!--mstheme-->Partial code only received. Try again. If not okay use different key. If not go to main dealer <!--mstheme-->
</TD></TR><TR><TD vAlign=top width=395><!--mstheme-->1:5 <!--mstheme--></TD><TD vAlign=top width=504><!--mstheme-->Key not programmed into PATS. Program key as above using master <!--mstheme-->
</TD></TR><TR><TD vAlign=top width=395><!--mstheme-->1:6 <!--mstheme--></TD><TD vAlign=top width=504><!--mstheme-->Faulty link between PATS module and EECV Go to main dealer <!--mstheme-->
</TD></TR></TBODY></TABLE>