I have a carb I got from a guy who had no ide what it came off of. It's a 9834 number on it. I got a lot of info from Holley's website, but no application data.

Here's what I have:

List 9834

Style : 4160
Renew Kit: 37-720
Trick Kit: 37-933
Needle and Seat: 6-506
Primary Jet: 122-642
Secondary Plate: 134-39
Power Valve: 125-65
Discharge Nozzle: .031
Secondary Spring: Black

It has a Ford kickdown and an electric choke. I figure its a non-OEM replacement, but the 642 jet leads me to believe its keyed to an emissions application. It has the idle screws on the sides of the primary block, so it's a pre 80's application I think. If I remember right, 80's up had four corner idle. Not sure though. I found carbs listed that use the same kit but have a 68 jet under the numbers 6619, 9834-3, and 89834.

Anyone know what this came off of? My 390 is about to suck the Quadrajet I've had on it down the intake. The Q-jet runs great, and gets reasonable economy, but this engine wil pull every bit of the fuel out of the bowl in 5 seconds. It wants more fuel capacity. I'm running an Airtek 362 machanical pump (428 CJ) I'm thinking of kitting the Holley and jetting it at 68 to start and putting in an 8.5 power valve. My idle vacuam is 15.