94 Ranger Clutch Problems
I downshifted the other day and noticed then that something didn't feel quite right about the clutch. Then when I went to shift again, I couldn't get it into gear. The reservoir had plenty of fluid in it and there are no apparent leaks around the master cylinder or from the bottom of the tranny where the slave would leak from. I did replace the master cylinder since it was the easiest fix without dropping the tranny, but that didn't seem to help any at all (I read about all of the bleeding issues and think I have all of the air out of it). If you start it in gear, the truck will creep forward like the clutch isn't fully disengaged. Could the slave cylinder be bad and not leak any fluid? Also, I couldn't match the RPM's up and shift it without the clutch when I was getting it home. Is this normal or was I just not pulling on the shifter hard enough?