Thread: main and rod bearing wear - low oil press. +
View Single Post
  #6  
Old 10-17-2005, 12:20 AM
madclone's Avatar
madclone
madclone is offline
Junior User
Join Date: Sep 2005
Posts: 93
Likes: 0
Received 0 Likes on 0 Posts
2 monsterbaby

my engine is half-removed it holds only to wire harness, fuel and AC lines. To get to the cranckshaft I had to lift it up 20 cm. To get to the camshaft I have to take the front cover off, right? And then pull it out of the bore? Can I get the camshaft out without taking off cylinder heads and valve rods/lifters?

2 ken1mod

comrade, please give me a link on your toipc, if possible. I'm not sure I can find it
 
Reply Like