Originally Posted by
jimandnena
I REALLY wanted a rocker switch but couldn't find one that would work so I went with the toggle. If I find a rocker in the future, I can swap it out easily.
jim
PM me with your mailing address---I've more than a few that'd be suitable for this----some left over from my project. They'll be (On) Off (On) which is pretty much what the factory uses. A square hole in the B Pillar and trim might be necessary if you want them fitting close to their mounting surface.
Take a closer look at mine---they sit on a piece of 18ga sheet metal, trimmed to fit with help from a Dremel tool---and some skin I wasn't using anyway.