ever get it to work properly ?
I'm installing 2006 KR seats in my 99 f250 SD. they have up-down, back-forth, heat and memory. i can get them powered to move but no memory and as far as heat can i just add the switch or do they need to go to the EATC=Automatic Electronic Temp Control which would be the climate controls correct? but instead of the manual ones they are the digital ones.
can i by-pass the EATC and just put a switch i see from the diagrams that the sensors are in the seat cushion so the safety issue of over heating is OK correct?
these are the seats the drivers has memory they both have power and heat and the sticker on the drivers seat says it passed inspection in 2006 so that's how i figure the year.
when i looked up the diagrams on Auto zone the only ones that seem to fit my seats where 2005 here is a pic of the drivers side connector each wire labeled