Hi, so i get to work to day and notice that my front right warn hub is entirely gone!
The truck is a 75' f-100 300-6 4 speed 4x4 with a d44 up front, i think it probably hapened because i didn't clean out the hub after driving through a lake
Replacing the hub itself isn't really the problem, the problem is that the tip of the axle tube where the hub seals up to the axle tube is all bent out of shape. I was wondering if anyone has any good ideas for reshaping the housing so the hub will seal properly again (and hopefully not fill with water and blow up). I'm open to anything but i reeeeeaaaaly don't feel like replacing the whole axle
Thanks