Hi guys, The tools I am using are the ones you get from rosewood tools, they are exactly like the ones from whitaker tools ( the large tap + screw puller) and the tool to drive them in. The sealant in the picture is MUCH thicker than the crap I used, When I remover the old cups I could not see any visible cracks in the cups, could the old cups just have been warper or lost any factory sealant that was on there? I am at a loss as to why they were leaking in the first place. I guess I will get 8 new cups, a couple of tubes of 620 and try one more time. Any tips on how to make sure the cups are straight when you put them in, I did put one in crooked the first time and had to re-order another cup and re-install it. wish me luck and I will keep you informed of my good luck this time. Thanks, Bill