I have a 1994 4x4 supercab ranger with the 4.0, push button 4x4.


question 1. does anyone make an aftermarket manual hubs for this truck?

question 2. when I push the button for the 4x4, it will move the transfercase motor to the 4x4 position and then right back to two wheel drive. I have a brown wire hanging off the trasfer case (seperate from the motor wire plug) which I am thinking might be to a sensor to tell it that its in 4x4? maybe it's not getting signal there for its going back to 2 wheel drive? oh and the transfer case motor is brand new.

any help would be great

thanks, johull