#10  
Old 03-31-2011, 10:53 AM
bpounds's Avatar
bpounds
bpounds is online now
Hotshot
Join Date: Aug 2006
Location: Whittier, CA
Posts: 17,018
Received 55 Likes on 43 Posts
Originally Posted by going up 2!
I have a 2005 PSD all stock minus a turbo back.After a oil change from the xxxxxxship and the fuel filter change at home the truck starts,idles,and runs like crap.Low on power ect...Fuel pressure was about 52 right off the upper fuel filter housing.Held there while i gave throttle. I checked with a infared heat meter on exhaust manifold on each cylinder exit and all seen to be running at similar temps,was told i could see if a injector was bad this way. Removed and reinstalled filters,no change...any ideas?I been searching but cant seem to find any answers. Oh,the stealership said it was air in lines and should go beat the snot out of it to remove the air? Sounds like they want a truck to come in w/ a blown head gasket.Any help much appreciated.Thanks in adavance,Adam.
I don't see where you mentioned doing the key on pump prime x3 after the FF change. Did you do that? If not, that's your problem and don't worry about the other possibilities.