Got the ole hot rod fired up...Odd the valve cover gaskets no longer leak. I won hahahahaha

pics davey boy, pics!!!

walked past truck to get into the garage.

Here you go

http://i713.photobucket.com/albums/w...k/P1010103.jpg

http://i713.photobucket.com/albums/w...k/P1010102.jpg

http://i713.photobucket.com/albums/w...k/P1010104.jpg


During valve cover gasket replacement...
http://i713.photobucket.com/albums/w...k/P1010108.jpg

http://i713.photobucket.com/albums/w...k/P1010110.jpg

Dont have any pics of the completed engine compartment. But I will make sure that I get some monday.

Monday I start axle seals and rear brakes

One week down three weeks till race season starts! Still a lot of work.

good job man. i tell ya what, i loathe the idea of tearin down my 91 to get to the heads... thats a lot of stuff to take apart...

Ive done a few at work. This is the first one I aint getting paid for LOL

lol. i dont mind tearin into my dents, cause they dont start throwin codes and not runnin right if i put somethin back wrong. and i usually dont have to tear the whole truck down to get to what im doin either. lol.

Lots of short trips... and topped off the tank with 100% gasoline(No ethanol).

Are your fender aprons made out of steel? Sorry for the random question.

powerwashed engine bay.....planning the removal of donor eng....some maint to same while out, then install

mine are...

mine are made out of high tech. ultra light space age polymers...... PLASTIC


lol

The inner fenders are yeah. the outer ones are steel & Rust

moved it to a parking spot..lol

Thanks for all the replies. Mine are also plastic. I wonder if it is on the higher trim levels that they have the steel aprons... I wish mine were steel though, they are starting to sag.