When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I may run a smaller hole just above the mount to keep the light mount in place. Not sure one of those flat lock washers (with the little points) would hold it or not.
I thought of drilling through the bracket that square tube goes through, but that made me a bit nervous...figured where it is mounted now doesn't do a lot structurally. I still need to add the wiring and diodes to make them come on with the reverse lights or manually with the switch.
I may run a smaller hole just above the mount to keep the light mount in place. Not sure one of those flat lock washers (with the little points) would hold it or not.
I thought of drilling through the bracket that square tube goes through, but that made me a bit nervous...figured where it is mounted now doesn't do a lot structurally. I still need to add the wiring and diodes to make them come on with the reverse lights or manually with the switch.
Nice job, it's great seeing a hitch without rust on it.......
here is my electrical control center under the middle seat...