Here is the list that i received to choose from:

Heavy tow 40 hp
Aggressive tow 65hp
mild street economy 90hp
aggressive street economy 120hp
hybrid race 140hp
ultra comp (head studs only) 160hp

 

Glad you come over here. FTE is a little bit different from the .org, hope you enjoy it.

In all honesty, I have never seen Street Comp on any list when he was doing SCT products. I don't know if it was something that he was testing and it just never got off the ground or what. I did email him to see if I could get a new version of it for his Phalanx, haven't hear back from him on that yet. I'll let you know on that.


They do have an email for 6.0 calibrations, but I guess they still haven't activated it yet.

 

I run a custom ASE as a daily driver,it is hands down the best all round tune I have ever had in the truck.Once Spartan gets a tune dialed in it is mind numming how smooth and powerfull your truck will run.The best thing is I get 20 plus MPG on the highway easily.So I would say you should give it a try.

 

tex. I sent you a pm.

 

Got it. Is there any time preference tomorrow?

 

any time after 3:3o would be good.

 

I forgot to mention that a tighter housing might help with spooling of the 64 to offset when your tranny downshifts.

 

Well, after much debate I ordered the Phalanx today from Jared @ Spartan. I actually got if for $50 less than what I quoted for being a Beta tester. I only want the best for my truck and the Phalanx is it! I ordered the

Heavy Tow
Aggresive Street economy
Hybrid Race

I inquired about the EGT cable etc., that I need for the Phalanx. Jared was unsure as to when it would be available. I've read a post on the Spartan forum listing everything needed but a few of the links no longer work. I will not run the Phalanx without the EGT's being monitored. Does any body have any new info as too what and where I can purchase the needed equipment?

Thanks

 

Here you go Sir, I ordered the parts from this link:
http://www.dashdaq.com/forum/viewtopic.php?f=7&t=587

Sorry I didn't hot link it, but I'm stuck posting over a smartphone and I couldn't activate the link button and I wasn't sure what the code was for this board. The link shold work if you cut and paste it. I'll fix it someone else doesn't before I get back to a real computer.

I haven't received all of the parts yet, but I'll install them and report back here when I do.

I hope that helps.

 

Thanks for the link. I will get everything ordered. Looks like the only tricky part may be getting the EGT's to read without decimal's. Looking forward to your report back on install tip's. Thanks again

 

I wrote the info about reading EGT using a Phidget.
I am out of town for a few days, but I will write up the procedure to eliminate the decimals when I get home. It is easy and works great!

Charlie

 

Cool!!! I was just setting around wondering how I'd do that part when the phidgets sensor arrives. I have already received the thermocouple, connector, and adaptor cable. I also have to check the size of bit and tap needed for the thermocouple.

Thanks Charlie!

 

If you find the info for the bit and tap size please post. I have not seen that info in a while. Need to get everything ordered today.

 

I have just ordered everthing also. The sensor web site list the thermal coupler as having a 1/8 npt, i have two tap and die charts, one says 11/32 drill one says 5/16 drill. Iwould like to see the instructions for getting rid of the decimal reading also.

Rob

 

Mine is on the way!! ships out today.