Anyone in CNY time IDI motors
#1
Anyone in CNY time IDI motors
Hey guys,
I'm wondering if anyone local-ish has the equipment to properly time my 7.3 diesel. I'm located about halfway between Syracuse and Rochester. I just bought the truck and it's a little hard starting with crap mileage. I can't afford injectors yet (truck has 200k) but I'm hoping timing it should help some.
Thanks!
I'm wondering if anyone local-ish has the equipment to properly time my 7.3 diesel. I'm located about halfway between Syracuse and Rochester. I just bought the truck and it's a little hard starting with crap mileage. I can't afford injectors yet (truck has 200k) but I'm hoping timing it should help some.
Thanks!
#2
I am not too familiar with diesels to begin with. Have you checked with Regional International on 5&20/Gates Rd? I believe that the 7.3 was built by International for Ford. Also, I am not sure who does diesel work in our area but I would think that the local dealers would have the means of doing this.
#3
I am not too familiar with diesels to begin with. Have you checked with Regional International on 5&20/Gates Rd? I believe that the 7.3 was built by International for Ford. Also, I am not sure who does diesel work in our area but I would think that the local dealers would have the means of doing this.
#4
#5
I'm not afraid to drive to Rochester or Syracuse either but Conestoga Diesel (Southern P.A.) is a little too far to drive for me unless nobody else can do it and if that ends up being the case it'll wait until I can get new injectors and a new pump as well.
I would think maybe Regional could do it with all these farms around someone is bound to have one of these old motors. That's the only problem from what I've read, this engine hasn't been made since 94 so most shops don't have the equipment kicking around anymore.
Thread
Thread Starter
Forum
Replies
Last Post
Hellbender75
6.0L Power Stroke Diesel
11
07-16-2018 07:20 AM
SuperKram
General Diesel Discussion
4
08-11-2008 05:39 PM
somairot
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
1
02-23-2006 11:10 PM