Hello, I have done a search on here for the clutch assemblies, the pressure plate, disc, and throw out bearing, but I have not seen many comments about them. NAPA has one that runs around 300, and then there is the ones from one of our sponsors, Rock Auto that sells the complete kit and it is much less in money than the NAPA parts. Has anyone tried these kits from Rock Auto? I am replacing the clutch for my 1990 F350 SCLB 460 and the ZF5. I am leaning towards the Rock Auto, but before I spend money, I want to make sure I am getting quality parts that I don't have to replace anytime soon. BTW, I will be towing occasionally my 18+2 trailer, a 17' boat and maybe sometime a pull behind camper. Thank you for your time.

 

I prefer Luk. I found a lot of Luk clutches installed by Ford at the factory. I always either resurface or replace the flywheel when I do a clutch.

 

I have had great experiences with Luk and Luk HD clutch sets.

 

I have been reading up on them thank you for the point in direction. I also saw a 12" HD clutch. I read that they need to have a stronger clutch master cylinder and actuator. I don't want to have to replace this clutch again anytime soon. I want to make sure I get one that will last for years. Any information on this will be greatly appreciated.