I have to replace bushing on the axle mounts. It's a 1 1/4 bar. Are the bushings made small to make sure of no movement? I'm also replacing the left and right arms. Is there any tricks to making sure I'm on center with the bar? I'm rebuilding the whole front end and this is the last item I have to do. Is there a video available for this.

 

It will all come together when you do it and will seem obvious. Great improvement after it is done.

 

Should be a bolt in with no adjustments and everything should align just fine for you.

I would go with Urethane bushings like Moog or Energy if you haven't already bought them. Made a huge difference in stiffening up my old 88 F250.