Driveshaft question
#1
Driveshaft question
im doing a idi swap in my truck and using a c6. but it has the longer tailshaft with a slip yoke, vs the c6 that came out with a short tailshaft and bolted yoke.
does anyone know if theres a truck i can pull a shaft from? 1 piece, i dont mind shorting it..
has dana 60 rear, long bed 2wd.
i hear people going to junkyards and getting shafts from other trucks and getting a close fit
does anyone know if theres a truck i can pull a shaft from? 1 piece, i dont mind shorting it..
has dana 60 rear, long bed 2wd.
i hear people going to junkyards and getting shafts from other trucks and getting a close fit
#2
im doing a idi swap in my truck and using a c6. but it has the longer tailshaft with a slip yoke, vs the c6 that came out with a short tailshaft and bolted yoke.
does anyone know if theres a truck i can pull a shaft from? 1 piece, i dont mind shorting it..
has dana 60 rear, long bed 2wd.
i hear people going to junkyards and getting shafts from other trucks and getting a close fit
does anyone know if theres a truck i can pull a shaft from? 1 piece, i dont mind shorting it..
has dana 60 rear, long bed 2wd.
i hear people going to junkyards and getting shafts from other trucks and getting a close fit
Thread
Thread Starter
Forum
Replies
Last Post
HIO Silver
1967 - 1972 F-100 & Larger F-Series Trucks
5
09-13-2013 12:09 PM
Karm239fh
Clutch, Transmission, Differential, Axle & Transfer Case
5
05-02-2005 05:12 PM
Randyb12
Clutch, Transmission, Differential, Axle & Transfer Case
1
03-15-2005 09:28 PM