ok thanks charlie u have been a huge help so far

 

That's what we're here for..... You may be helping me the next time

 

im here if ya need a set of hands. i work in columbia at apple soo im sure im close

 

Ha!!! Careful there, I'm on a walker, so I'll put you to work, lol

 

well due to a lack of a fuse and wire terminals i didnt get the alternator in also my short attention span kept me everywhere but mounting the alternator. i did however remove the harness from my 88 and spliced the green wire in to the factory conector so thats ready to go. i hope my old man pulls through for me and gets my list of parts from baltimore frieghtliner and p and h tomorrow!!!!!! i hope

 

Cool, Your getting there!!!

 

yeas yeas i am lol i wish it were done already though lol also i got the york compressor apart i got last weekend and i discovered it is a fully functioning in tact reman ufactured york 210!!!!! sooo all i need is a gasket set and clutch pulley for it and i can start that project

 

What's the compressor for? You putting air on the truck? I have one of those projects here too!!!

 

yes oba!!!!!!!! im preatty happy i found the compressor. got for a wopping 26 bucks!!!!!!

 

Ha!!!! I can help with that project too!!!!

 

excellent!!!! u are a great resource sir!!!!

 

Hahahaha, 's cause I'm and old fart!!!!!!

 

i am glad to report that i have finally stoped procrastinating!!!! i just ordered the harneses from rjm and will being doing the swap hopefully this week!!!

 

Great!!


You have to cut and solder the cable.


If you need help, let me know.

 

yea i noticed that!! lol i guess ill just have to give it the custom hack job!!! lmao im kindy antsy im thinking about taking the accesory bracket off my 88 today and taking the alternator over the shop this week and getting it cut out and cleaned up so all ill have to do is swap em over and run some wires!