1948-1952 ford truck parts
#168
sorry it took so long to get back to you on the 56 f600 fenders but I'm a Newbie email is roger.impala@live.com
#172
I can send photos of the hoods and the rear end. What would you like to know about the 2 speed?
#174
I had forgotten I had posted on your thread. This is for a project that is not on the front burner. I suppose with the way I am going the windows are not that important as it will not be a daily driver. Besides I am looking for "cheap". Thank you Jim
#177
Im not sure what bushings you are talking about. On the 53-56 models there were rubber bushing/washers that went between the fender and running board, but the 48-52s used fender welting and carriage bolts to my knowledge.
#178
Vent Windows (frames) and front air vent lid
Hi,
Do you have any good condition vent window frames left? my ones on my '49 F1 and rusted out. I have the glass so not bothered about that.
Also do have the air vent lid, again mine's completely rusty?
If you do, could you ship to Florida before the 27th, over in Florida from the UK for the until then?
Thanks
Richard
Do you have any good condition vent window frames left? my ones on my '49 F1 and rusted out. I have the glass so not bothered about that.
Also do have the air vent lid, again mine's completely rusty?
If you do, could you ship to Florida before the 27th, over in Florida from the UK for the until then?
Thanks
Richard
#180
Aha. I bought my 51 a month ago. It didn't come with running boards. Someone at a parts shop or on message board mentioned bushings, but they may have thought I was talking about a 53-56, or I misunderstood. Thanks.