Only go one way. The lights should be at 9 and 3. I didn't have to use the Allen on mine.

 

I had to use the allen wrench on one bulb out of 4. But upon reflection after the install it may have been installer error.
But as stated, point the chips exactly to the 3 and 9 o'clock positions. The photo below is not Beamtech brand, but it's the same orientation.

 

 

And when you remove the factory bulbs, make sure the o-ring seal comes out also.

 

 

One of mine out of the box needed to be adjusted to match the 9 and 3 positioning of the LEDs.

 

Just another one here with some input. I didn't have to adjust any of the 4 that i installed. they were at 9 and 3 on the dot when installed.

 

^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ and another , good out of the box ^^^^^^^^^^^^^^^^^^^^^^^^

 

Add me to that list too. Mine were good to go straight from box.

 

 

Some people have reported the beamtechs doesn't seat nice n snug on the housing...is that the case with any of u guys ?

 

mine were nice a tight. They "clicked" into place when you stick it in a rotate.

 

They fit snug for sure.
Maybe people reporting that removed the needed gasket?