When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
pretty sure the source of my leak was the EBPV. Pulled it all out and cleaned the valley. New EBPV delete , high flow outlet, to replace it but first now I can do the new UVCH gaskets, Riff Raff intakes, new down pipes ton of other stuff with all the room to work.
Someone mentioned checking the fuel line as vibrations from the hold down clamp can wear into the line and cause a failure. Since mine are easily accessible I found the wear marks. I will be replacing mine.
Someone mentioned checking the fuel line as vibrations from the hold down clamp can wear into the line and cause a failure. Since mine are easily accessible I found the wear marks. I will be replacing mine.
I also added a piece of rubber tube and then re-shaped the clamp to go over it. This will keep it from rubbing through on the new line you get.
Tim M
11-12-2018, 07:49 AM
