Hi all. Normally in the 57 to 60 forum but I have a question for you.

I pulled a 360 out of a '76 F250 and dropped it in a '58 F100. When I disassembled the front of the motor I took detailed photos so I could know what went where. Trouble is I can't find the photos. Everything is bead blasted, painted, and ready to go back on the motor. Does anyone have a good photo or an exploded diagram (or both) they can share to help me out?

thanks....

 

The FE harmonic balancer contains a single sheave pulley. Ford offered single, double and triple sheave outer accessory pulleys that bolt to the balancer to add P/S and/or A/C and/or dual belt alternators.

 

My 76' FE, hope it helps



Notes are from some other post I was helping with

 

Pulleys aren't the problem. I can probably muddle through reassembly via trial and error but with a good photo and an exploded view, it will be much easier.

 

 

Thanks Jakeharp. That will help.

 

This had a lower left alternator, upper left smog pump, and right power steering. Gonna have an alternator, power steering, and aftermarket AC. I may go with aftermarket to simplify.