specific cry thread. obs h2e + sd i/c WITH IDI COOLING SYSTEM
#1
specific cry thread. obs h2e + sd i/c WITH IDI COOLING SYSTEM
Yeah so, my specific question is, how the heck did you route the hot pipe?
With the IDI cooling system, the overflow/washer solvent is on the drivers side as you know. I have an early obs 7.3 powerstroke with the IDI cooling system (no degas). I have my air filter right next to the a/c compressor.
I can't run the hot pipe under the air filter housing, because it hits the steering shaft, and its like a friggin z pipe then. What the frick dude. Anyone else run into this problem? I know theres like .5% of people out there with this cooling system setup - let alone that run an h2e
cry mode, engage
With the IDI cooling system, the overflow/washer solvent is on the drivers side as you know. I have an early obs 7.3 powerstroke with the IDI cooling system (no degas). I have my air filter right next to the a/c compressor.
I can't run the hot pipe under the air filter housing, because it hits the steering shaft, and its like a friggin z pipe then. What the frick dude. Anyone else run into this problem? I know theres like .5% of people out there with this cooling system setup - let alone that run an h2e
cry mode, engage
#3
Join Date: Mar 2005
Location: Marlboro Mental Hospital.
Posts: 60,981
Received 3,102 Likes
on
2,164 Posts
Thread
Thread Starter
Forum
Replies
Last Post
Gold Dog
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
6
08-01-2006 04:24 AM