I'm trying this from my phone so hopefully it works. I went to my barn to look at my parts and pulled the spare wheel carrier after bringing it up and comparing it to the parts and accessories manual it looks like it's for a model d&y which would be an F2 and F3 can anyone confirm this by looking at the picture? It's definitely not the right one for my truck

 

Yup, that's the F-2/F-3 carrier. Stu

 

That's what i thought, thanks. i guess i'm SOL for my F1. Need one? I'll make you a whale of a deal.

 

Got three, but somebody needs it. Stu

 

I do. I sent you a pm.
Mike

 

Bill, They repop the F1 carrier.

https://www.npdlink.com/store/produc...681-50000.html

 

Well i'll be i had no idea. Back when i bought my truck they were scarce as far as i remember. This one came along with the truck and i never even looked at it until today. Guess i'll order one. Thanks for the heads up.

Mike, i didn't get your PM. Not sure why, i have plenty of room. I'll be out of town tomorrow but if i don't get the PM i'll get back to you. I don't have a use for it.

 

do they sell the rod to hold in the bar

 

Both the nuts and bolts are NLA for the F-2/3s and big trucks to my understanding. There are two lengths of the bolts. The F-2/3s are 10 3/4" while the big trucks' are 13 7/16". They share the nuts. On the half ton pieces I don't know about availability. Stu



Short set:



Long set:

 

Is this still available? I'm looking for the carrier and hardware for my 51 F3.

 

Yea, I never listed it and the other guy was in Canada and shipping was way too high. Since then I think I found both bolt and nuts that are not available anymore. I'll dig it all up this am and let you know what I have. Can you PM me your contact information

 

I'll get inline behind 303FordGuy for the parts. I have the tire carrier but no bolts & nuts.

 

Sorry 38coupe, i had to go in order of request...

The spare carrier and hardware are headed to Jeff, 303FordGuy, in Colorado.
I stumbled across the other bolt and nut while cleaning my garage the other week. How lucky it was that it didn't get chucked at some point. Anyways they need some TLC to get unfrozen along with a good thread chasing but otherwise they should work well. They were 10 3/4" long so they were for the F2-F3 series. Glad someone will have use for them. Hoping to see it restored and installed at some point so don't be shy with the pictures.