Category: Accessories
Price: $500
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): Hybrids
Item Condition: TX
Shipping Information: Item can be shipped
Engine: Part suitable for gas truck, Part suitable for diesel truck

I have a brand new, never been on an engine GT4082 (journal bearing) non waste-gated turbo. This turbo is built for the DT466E and the I530 engines built by International. It has a T4 universal exhaust flange for easy install on the project of your choice. It has a 82mm compressor wheel with 50 trim .58 A/R compressor housing, and a 77mm turbine 84 trim 1.19 A/R turbine housing. This gives it immediate low end power along with some top end oomph without major back pressure concerns that came with the .94 A/R turbine housing, or the laggy spool up that came with the 1.34 A/R turbine housing. The 1.19 A/R turbine housing was a special option on this turbo. Would be a great project turbo for a gas engine larger than 5.0L. This turbo will support up to 650HP per Garrett website specs. It will easily push 40 psi of boost. Diesel Innovations sells kits to mate this turbo to the 7.3L ($$$$$=power).

These sell for $1100 and up at the truck shops. Oil feed/drain kits are easy to find for this turbo.

Photos to follow tomorrow when I get a camera that works...

 

Here are some photos.....better late than never. DI in Houston no longer carries the T4 kits, but they told me they are fairly easy to find.

 

SOLD today!!!