Ford Truck Enthusiasts Forums - View Single Post - Carb Jetting with Dual Fuel Setup
View Single Post
Old 08-07-2014, 11:16 PM
FrankGRUN FrankGRUN is offline
Junior User
Join Date: Jun 2010
Posts: 77
FrankGRUN is starting off with a positive reputation.
After some research, I've found that the IMPCO 425 mixer will cause a pressure drop of between 0.6 and 1.4 inches of water over the maximum rpm range I anticipate using. The right angle adapters are much less of a problem. Calculations at 500 cfm and atmospheric pressure for a 4" diameter round duct into a 5.25 inch plenum show less than a 0.2 inch of water impact. I have a low pressure manometer and I intend to measure the full pressure differential from my cold air intake/ Spectre in line air cleaner approach to the plenum above the IMPCO mixer when I finish this thing. In the final configuration, I'll be using the IMPCO Commander feedback control to adjust the operating air/fuel ration with the LPG operation.
Reply With Quote