Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: My4Fordtrucks
Showing results 1 to 15 of 500
Search took 0.24 seconds.
Replies: 20
Views: 505
Posted By My4Fordtrucks

NP-405? No such creature that I’m aware of....

NP-405? No such creature that I’m aware of. Perhaps you meant to type NP-435?
Yesterday, 06:08 PM
Replies: 8
Views: 324
Posted By My4Fordtrucks

Toed in is only slightly “pigeon toed” so it will...

Toed in is only slightly “pigeon toed” so it will not become more toed in when driving. When driving down the road the tires will try to pull further apart. Front drive vehicles are set up slightly...
Yesterday, 05:48 PM
Replies: 8
Views: 324
Posted By My4Fordtrucks

Yes? Toe in means that the front of the tires are...

Yes? Toe in means that the front of the tires are closer than the rear

front of vehicle
/ \


Toe out is generally on front wheel drive vehicles

Front of vehicle
\ /
Yesterday, 04:46 PM
Replies: 7
Views: 230
Posted By My4Fordtrucks

That looks terrible.

That looks terrible.
Yesterday, 03:46 PM
Replies: 6
Views: 204
Posted By My4Fordtrucks

That would only be applicable if you were...

That would only be applicable if you were installing new tires. No one is going to take the chance of damaging the tire bead by removing it to balance the wheel by itself. If a wheel is bent you...
Yesterday, 03:03 PM
Replies: 20
Views: 505
Posted By My4Fordtrucks

The 302 changed to the 351W firing order but...

The 302 changed to the 351W firing order but hasnít the 351W always been the same?
Yesterday, 11:10 AM
Replies: 20
Views: 505
Posted By My4Fordtrucks

You need to use the 351W firing order on the...

You need to use the 351W firing order on the 351W.

The flat tappet cam cam is made different than the roller cam. The gear on the distributor and / or camshaft will be damaged if they are not...
Yesterday, 11:02 AM
Replies: 17
Views: 629
Posted By My4Fordtrucks

Yes, GM put the 4.3L in their trucks but I...

Yes, GM put the 4.3L in their trucks but I thought this was a Ford vs Ford question. A friend of mine had an ex state highway administration truck with the 4.3 and he said he probably would have...
07-21-2019, 03:28 PM
Replies: 1
Views: 149
Posted By My4Fordtrucks

No. It would have a brass spring loaded pin and a...

No. It would have a brass spring loaded pin and a brass ring on the back of the horn pad. I would first check for power at the horns located behind the upper stone deflector on the core support below...
07-21-2019, 03:17 PM
Replies: 5
Views: 271
Posted By My4Fordtrucks

You should be able to find a rubber cap in the...

You should be able to find a rubber cap in the “Help” section at the parts store. For some models there was a hose that went from the throttle body to the radiator. Maybe a different (heavy duty?)...
07-21-2019, 09:31 AM
Replies: 10
Views: 348
Posted By My4Fordtrucks

How does replacing the switch bypass the wiring...

How does replacing the switch bypass the wiring to the intermittent control module?

On the Ď87-91 trucks, turning the switch clockwise is for low and high speed. Counterclockwise is for...
07-21-2019, 08:09 AM
Replies: 1
Views: 162
Posted By My4Fordtrucks

MAF overlay harness testing help

Since the MAF conversion, I have had cold start issues: rolling idle and stalling. I have a continuous memory code 15 for loss of keep alive memory. After a few minutes it will eventually relearn and...
07-21-2019, 07:18 AM
Replies: 10
Views: 348
Posted By My4Fordtrucks

It happens. I’m right there with you...

It happens.

I’m right there with you thinking the motor is the problem.
07-21-2019, 06:49 AM
Replies: 4
Views: 208
Posted By My4Fordtrucks

After retrieving codes, Iíd check the throttle...

After retrieving codes, Iíd check the throttle body for binding and carbon buildup. I have had several throttle bodies wear out over time. The shaft will move in the bushings allowing the butterflies...
07-21-2019, 06:39 AM
Replies: 10
Views: 348
Posted By My4Fordtrucks

The problem with that is he has a 1990 model so...

The problem with that is he has a 1990 model so the wiper switch is on the dashboard.

Maybe its itís just been my good luck but I have never had a wiper delay module go bad. More often than not...
Showing results 1 to 15 of 500
 


 
Forum Jump

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.