Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: alz
Showing results 1 to 15 of 500
Search took 1.07 seconds.
12-24-2018, 07:11 AM
Replies: 8
Views: 321
Posted By alz

Thank you, Tim and Happy Holidays to all our FTE...

Thank you, Tim and Happy Holidays to all our FTE family.
12-11-2018, 04:33 PM
Replies: 1
Views: 421
Posted By alz

Slip yoke clunk

I've have got a 2014 F150 Crewcab w/5.5' bed, singe piece driveshaft. I purchased the truck from the local Ford dealer with roughly 50k miles and it now has 60k miles. It was buttery smooth for the...
08-30-2018, 06:26 AM
Replies: 9
Views: 810
Posted By alz

I would suspect bad fuel from the last fill up.

I would suspect bad fuel from the last fill up.
11-20-2017, 03:56 PM
Replies: 18
Views: 3,347
Posted By alz

My 99 has the same issue with cutting out during...

My 99 has the same issue with cutting out during left turns. I've only noticed it when the fuel level was below 1/4 tank.
I have had the issue in a straight line under heavier than normal...
05-15-2016, 02:25 PM
Replies: 8
Views: 911
Posted By alz

Pull the trim panel around the radio and climate...

Pull the trim panel around the radio and climate control. It just pulls out, no screws. Disconnect connector for 4x4 switch, if equipped. Then there are four screws that hold the climate control to...
05-15-2016, 11:04 AM
Replies: 8
Views: 911
Posted By alz

The replacement I purchased on ebay were complete...

The replacement I purchased on ebay were complete with the bulbs already in the sockets. No soldering. Just a 1/8 turn in/out with a flat blade screwdriver.
05-02-2016, 04:37 PM
Replies: 8
Views: 911
Posted By alz

Just an update. I tried replacing the bulb with...

Just an update. I tried replacing the bulb with some I had at work but they ended up being less than 12V and burned out within a couple days.
I ended up purchasing a couple replacements on ebay:...
04-12-2016, 04:24 AM
Replies: 3
Views: 590
Posted By alz

At the very least, you will have to remove the...

At the very least, you will have to remove the bolt through the one side.
04-11-2016, 07:15 PM
Replies: 7
Views: 706
Posted By alz

I just installed the Monroe 90010 kit on my 4x4...

I just installed the Monroe 90010 kit on my 4x4 Expedition. You will need a spring compressor to install the springs. I used one I purchased from Harbor Freight and it worked fine.
One of these:...
04-11-2016, 04:21 PM
Replies: 8
Views: 911
Posted By alz

Auto Temp panel bulbs 99 Expedition

New owner of a 99 Expedition.
Looking to replace a couple of the bulbs behind the Auto Temp Control panel.
I have searched and even tried the dealer. The manual control uses a standard 194 bulb...
02-22-2009, 07:59 PM
Replies: 35
Views: 1,012
Posted By alz

How are the u-joints in the driveshaft?

How are the u-joints in the driveshaft?
02-19-2009, 01:23 PM
Replies: 4
Views: 298
Posted By alz

The doors should be pre-wired. You could just...

The doors should be pre-wired. You could just pop one panel off to make sure.
02-19-2009, 01:20 PM
Replies: 10
Views: 308
Posted By alz

I can't remember for sure, but I thought it was...

I can't remember for sure, but I thought it was bolted. If you tack it to the carrier you may warp it from heat. This is going to cause an erratic signal and the speedo to bounce around.
02-19-2009, 11:36 AM
Replies: 1
Views: 360
Posted By alz

Sounds like a ground issue if the tach was...

Sounds like a ground issue if the tach was jumping as well. If it were just the speedo, I would say to check the RABS on the differential.
02-19-2009, 11:34 AM
Replies: 10
Views: 308
Posted By alz

The tone ring needs to be tight, no play. Any...

The tone ring needs to be tight, no play. Any abnormalities in the ring, and the RABS will pick it up and cause the speedo to jump around. Make sure the ring is perfectly straight and the teeth are...
Showing results 1 to 15 of 500
 


 
Forum Jump

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.