Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: quig757
Showing results 1 to 15 of 43
Search took 0.63 seconds.
12-20-2005, 09:26 PM
Replies: 0
Views: 414
Posted By quig757

Ticking 4.0 OHV

My 91 had been ticking badly since it got real cold here. I tried changing the oil and it got worse (coincidence) Then I lost a cylinder. The end rocker arm pedistal bolt broke. The broken piece...
02-27-2005, 10:09 AM
Replies: 9
Views: 753
Posted By quig757

check the explorer forum, You will see what I had...

check the explorer forum, You will see what I had to do
02-27-2005, 09:36 AM
Replies: 15
Views: 754
Posted By quig757

My 86 B2 had the same thing. The overdrive sprag...

My 86 B2 had the same thing. The overdrive sprag broke. This is not a hard job and is common on these transmissions. The hardest part is R&R of the trans.
02-27-2005, 09:32 AM
Replies: 7
Views: 6,260
Posted By quig757

I had a similar problem, drove me nuts. Turns out...

I had a similar problem, drove me nuts. Turns out the fuel fill pipe at the quarter panel was rusted through, allowing sand and dirt into the fuel tank. Ihad to drop the tank and clean it and the...
02-27-2005, 09:25 AM
Replies: 9
Views: 477
Posted By quig757

Get both, Explorers are just 4x4 station wagons....

Get both, Explorers are just 4x4 station wagons. They are great for the above reasons, but not really good for towing heavier loads. Especially the earlier ones with A4LD trannys. For your parts...
01-26-2005, 07:32 AM
Replies: 2
Views: 555
Posted By quig757

Its not too bad to do if you have a torch to heat...

Its not too bad to do if you have a torch to heat the exhaust nuts and many extensions and swivels. Some of the bellhousing bolts are hard to get at
12-07-2004, 08:05 AM
Replies: 3
Views: 462
Posted By quig757

jclj2003 Senior User is right, but I have...

jclj2003
Senior User is right, but I have one good hub if youre interested since I converted to manuals too
12-07-2004, 07:58 AM
Replies: 2
Views: 335
Posted By quig757

I know, but things are expensive here and we got...

I know, but things are expensive here and we got snow yesterday and I got nervous,
12-07-2004, 07:56 AM
Replies: 7
Views: 355
Posted By quig757

sure pm me

sure pm me
12-06-2004, 03:19 PM
Replies: 2
Views: 335
Posted By quig757

Manual hubs

I just replaced my auto hubs on my 91 Explorer and for the first time since I've owned it its not just a big station wagon. The howl from the front is gone too. Warn hubs and spindle nuts were $256...
12-06-2004, 08:53 AM
Replies: 7
Views: 355
Posted By quig757

I have one from a b2 with shifter.

I have one from a b2 with shifter.
Forum: Engine Swaps
09-02-2004, 11:52 AM
Replies: 9
Views: 668
Posted By quig757

I think FE motors use the same bell

I think FE motors use the same bell
08-31-2004, 11:55 PM
Replies: 10
Views: 5,343
Posted By quig757

RWD 3.8s have nothing in common with a 302. I...

RWD 3.8s have nothing in common with a 302. I would put in a 302 since they are about the same size and have the same bell pattern
Replies: 5
Views: 538
Posted By quig757

Drive the pin out from the bottom with a small...

Drive the pin out from the bottom with a small punch
07-22-2004, 07:12 AM
Replies: 2
Views: 492
Posted By quig757

My 86 Bronco II did the same thing. It was the...

My 86 Bronco II did the same thing. It was the o/d sprag. I had an extra 2wd A4LD so I just replaced the sprag. r&r of the trans is the worst part.
Quig
Showing results 1 to 15 of 43
 


 
Forum Jump

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.