Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: 61steven
Showing results 1 to 15 of 500
Search took 0.27 seconds.
08-23-2017, 03:37 PM
Replies: 11
Views: 611
Posted By 61steven

Nothing is really wrong with the 400 so to speak....

Nothing is really wrong with the 400 so to speak. I drive it daily. It leaks oil like a civ and could use a timing chain. It makes alright power, but it also won't blow the tires off. I've wanted a...
08-23-2017, 11:39 AM
Replies: 11
Views: 611
Posted By 61steven

The boat was set up to take raw water though it...

The boat was set up to take raw water though it was never exposed to salt. Fingers crossed the water jackets arent going to be an issue then.

Could you explain a bit more on the cylinder to wall?...
08-22-2017, 01:40 PM
Replies: 11
Views: 611
Posted By 61steven

Drag boat 460 swap

Afternoon chaps,

I have been given an old drag boat with a nice 460 in it. The engine has been built over the years. Currently with an unknown aluminum intake, iron heads, holly 750, msd 6al, and...
05-13-2016, 11:52 PM
Replies: 11
Views: 672
Posted By 61steven

Im assuming its a bad gasket or vacuum leak...

Im assuming its a bad gasket or vacuum leak inside the carb. I really hope that its not the metering rods, as those are tricky to change.

What really stumps me is the fact that it runs fantastic...
05-12-2016, 11:30 PM
Replies: 11
Views: 672
Posted By 61steven

I have not milled down the choke horn, as much as...

I have not milled down the choke horn, as much as i would like to. The truck normally idles between 600 and 1000rpm depending on how warm the engine is. Normal vacuum is a solid 10 to 13 in/hg.

I...
05-12-2016, 11:26 PM
Replies: 11
Views: 672
Posted By 61steven

here is a video Holley carb issues - YouTube

here is a video

Holley carb issues - YouTube
05-12-2016, 11:03 PM
Replies: 11
Views: 672
Posted By 61steven

Both carbs have a choke, but no cable installed....

Both carbs have a choke, but no cable installed. I've only needed to use the choke in sub zero temps. The engine was warmish for testing both carbs.
05-12-2016, 10:57 PM
Replies: 10
Views: 1,216
Posted By 61steven

If you dont have the inhale and exhale side...

If you dont have the inhale and exhale side warmed up, 3" won't do much good. However, it wont do much harm either so if you already have the mufflers, run them.
05-12-2016, 10:55 PM
Replies: 11
Views: 672
Posted By 61steven

Persistent Carb Issues

Hello all,

I have a Double Pumper 650 (non-4 corner adjustment) that is constantly giving me fits. Its got a fresh rebuild kit on it, and i have yet to have the thing run properly.

It will not...
02-27-2016, 12:28 AM
Replies: 6
Views: 1,126
Posted By 61steven

Thank you for the advise, guys. It seems...

Thank you for the advise, guys.

It seems like the trans and t-case need to come out on their own. What is the trick to getting the top and bottom bolts on the mating tunnel? It seems like one is...
02-26-2016, 11:41 AM
Replies: 6
Views: 1,126
Posted By 61steven

Np435/205 removal

Hello guys,

Within the coming month I am planning on pulling my trans and tcase to reseal them. What is the best way to get those two out without removing the engine or the cab?

It looks...
07-11-2015, 12:35 AM
Replies: 9,930
Views: 928,089
Posted By 61steven

I took a few photos and drove it to work! That's...

I took a few photos and drove it to work! That's about it for today.
http://i807.photobucket.com/albums/yy358/sho_ter/BampW%202.jpg...
07-11-2015, 12:27 AM
Replies: 15
Views: 1,279
Posted By 61steven

You already have the D44 in, so why not at least...

You already have the D44 in, so why not at least try it and see how far you get?


There are many parts to beef up a D44. Chromoly axle shafts and CV shafts have been known to take quite a...
05-13-2015, 11:24 PM
Replies: 17
Views: 1,470
Posted By 61steven

4v 5.4l FORD engines came in Lincoln navigators...

4v 5.4l FORD engines came in Lincoln navigators and are some of the best mod motors. 3v truck engines are the second best. They really are good engines for the bad rap they receive. Plenty of RPM and...
05-13-2015, 11:09 PM
Replies: 11
Views: 810
Posted By 61steven

Fuel Fire

So I had a small fire last night. A fan belt had worn a hole through the fuel filter and ignited when stopped at a gas station. Luckily the clerk was quick with getting an extinguisher before the...
Showing results 1 to 15 of 500
 


 
Forum Jump

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.