Ford Truck Enthusiasts Forums - Search Results

Notices
Search: Posts Made By: xchief1320
Showing results 1 to 14 of 14
Search took 0.50 seconds.
Forum: 3.0L V6
07-31-2005, 12:20 PM
Replies: 6
Views: 798
Posted By xchief1320

The FPR was one of the first things i checked,I...

The FPR was one of the first things i checked,I have had them rupture and leak fuel out the vacuum port before..

Thanks
Steve
Forum: 3.0L V6
07-30-2005, 01:59 AM
Replies: 6
Views: 798
Posted By xchief1320

Sorry for the delay i haven't had alot of time to...

Sorry for the delay i haven't had alot of time to mess with the truck lately..But i did check the fuel pressure and it's fine.I thought it was a bad FPR as well at first..

I am going to try to...
Forum: 3.0L V6
06-05-2005, 07:37 PM
Replies: 6
Views: 798
Posted By xchief1320

The ECU has yellow writting on it like a JY...

The ECU has yellow writting on it like a JY uses,so that leads me to believe it isn't original.
I put a brand new MAF on it as well as cleaned the original stock one..

The engine isn't the...
Forum: 3.0L V6
06-05-2005, 06:11 PM
Replies: 6
Views: 798
Posted By xchief1320

might have a bad ECU,need ford part # for 93 ranger 3.0 MT

I am trying to track down a problem my truck is having and it all points to the ECU.So i want to get another one to try,Problem is the one in my truck isn't the original one and i'm not sure if it...
06-02-2005, 12:55 AM
Replies: 14
Views: 420
Posted By xchief1320

Yes,I had the battery disconnected the whole time...

Yes,I had the battery disconnected the whole time i R&R'd the intake. So the computer was without power for an hour or so..I also cleared the codes with the scanner.But when i redid the KOER it...
06-01-2005, 11:47 PM
Replies: 14
Views: 420
Posted By xchief1320

a little follow up on this nitemare..lol I...

a little follow up on this nitemare..lol

I checked all the wiring and it seems to be fine .
Did a leak down test and the motor has 12% or so leakdown and all cylinders are within a few % of each...
05-23-2005, 11:07 PM
Replies: 7
Views: 538
Posted By xchief1320

on my old T2.3 ranger i used to haul my bike...

on my old T2.3 ranger i used to haul my bike around alot and when loading up the bike half the weight of the bike + me would be on the tailgate at once as i pushed it up the ramp.you figure atleast...
05-23-2005, 08:15 PM
Replies: 14
Views: 420
Posted By xchief1320

I did check the wiring to the 02's but they are...

I did check the wiring to the 02's but they are maxed out and are not switching.the voltages never drop below .98V i tried to unplug the 02's just to see if anything changed and it did not make a...
05-23-2005, 01:40 PM
Replies: 14
Views: 420
Posted By xchief1320

Also what does the 3.0 use to determine load if...

Also what does the 3.0 use to determine load if it doesn't have a Baro or MAP sensor? does it run just off the MAF?

Thanks
Steve
05-23-2005, 01:39 PM
Replies: 14
Views: 420
Posted By xchief1320

when i ran a KOER i believe they were a 173 and...

when i ran a KOER i believe they were a 173 and 175 code..
when i did a KOEO it said system passed and no codes were given..

and the timing is set to 10 degrees with the spout disconnected..
...
05-23-2005, 01:02 PM
Replies: 14
Views: 420
Posted By xchief1320

none at all.I even ran it with the vacuum line...

none at all.I even ran it with the vacuum line disconnected to see if that fixed the problem.which it didn't..

What about the possibility that the "new" 3.0 they put in was from a flex fuel...
05-23-2005, 12:55 PM
Replies: 14
Views: 420
Posted By xchief1320

even if the fuel pressure is within spec? it's 39...

even if the fuel pressure is within spec? it's 39 psi with vac off.
I also checked to make sure the regulator diaphram wasn't busted..I have had a few regulators go bad and they would shoot gas out...
05-23-2005, 12:40 PM
Replies: 3
Views: 306
Posted By xchief1320

If the green relay doesn't fix it then it may be...

If the green relay doesn't fix it then it may be the EEC relay,which should be brown.It might be located right next to the Fuel pump relay,if not then it's near the EEC itself.
I have seen them burn...
05-23-2005, 12:30 PM
Replies: 14
Views: 420
Posted By xchief1320

bank 1 and 2 O2 not switching indicate rich..

Any idea on what to check? Vehicle is a 93 3.0/5 speed ranger.The guy i got it from said all this started after they put another 3.0 in it.but it ran fine in the truck they pulled the 3.0 out of..
...
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.