Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: steve(ill)
Showing results 1 to 15 of 500
Search took 0.55 seconds.
Today, 06:28 PM
Replies: 8
Views: 1,042
Posted By steve(ill)

Yea, maybe poor quality control (steel) on their...

Yea, maybe poor quality control (steel) on their part... maybe something stuck and things got real hot ... like I said, mine that after about 10 years and 180K miles...... how are the new discs and...
Today, 01:41 PM
Replies: 6
Views: 159
Posted By steve(ill)

you should be monitoring the suction side PSI...

you should be monitoring the suction side PSI also... that tells a lot..... When motor is off, you get 90-100 psi on LOW and HI side as it balances out... When you start the compressor it will pump...
Today, 01:38 PM
Replies: 6
Views: 159
Posted By steve(ill)

If it looses a can or charge overnight, you...

If it looses a can or charge overnight, you should be able to find it.... the dye might work... just a soapy water bottle sprayed on things might show up.
Yesterday, 07:05 PM
Replies: 1
Views: 155
Posted By steve(ill)

The old disc was not made for the new version of...

The old disc was not made for the new version of Windows... Normally there is a section called "PROGRAMS AND FEATURES" ... it might be in "CONTROL PANEL"..... from there you can tell the computer to...
Yesterday, 06:52 PM
Replies: 6
Views: 159
Posted By steve(ill)

why are you worried about the thermostat and...

why are you worried about the thermostat and cabin filter ? When properly filled, you get 45 degrees outlet.. That's GREAT !... how often do you add a can ? Once a year ? once a month ? I have a...
06-18-2019, 09:44 PM
Replies: 16
Views: 1,372
Posted By steve(ill)

apparently it is the software that was changed...

apparently it is the software that was changed for the 5.0 and 6.2 motors ONLY .

Ford is issuing a safety recall on select 2013 Ford F-150 vehicles equipped with 5.0-liter and 6.2-liter gasoline...
06-18-2019, 09:49 AM
Replies: 16
Views: 6,038
Posted By steve(ill)

Before you change motors, try some sealer... I...

Before you change motors, try some sealer... I have had EXCELLENT luck with BARS 1109 Copper head gasket sealer.. It mixes with the antifreeze, no need to drain.. Remove the top hose at the radiator...
06-18-2019, 09:41 AM
Replies: 5
Views: 234
Posted By steve(ill)

if the motor rotates by hand, and the battery is...

if the motor rotates by hand, and the battery is new.... then you have a problem with the starter / solenoid / dirty cables / master fuse / etc....................... but WHY did it loose power on...
06-17-2019, 09:13 PM
Replies: 7
Views: 498
Posted By steve(ill)

when you connect the gauge set or a new R134 can...

when you connect the gauge set or a new R134 can with a cheap gauge on the hose, you SHOULD read a pressure BEFORE you start to fill... If the system is properly charge, you might see 90- 100 pis...
06-17-2019, 08:57 PM
Replies: 1
Views: 373
Posted By steve(ill)

you cant do anything in place.. TOO tight to get...

you cant do anything in place.. TOO tight to get the cover off and work on the pumpkin. If you drop the axle down, then yes you can remove the insides and you will probably find a bad bearing......
06-17-2019, 08:49 PM
Replies: 16
Views: 6,038
Posted By steve(ill)

you can monitor the overflow tank level for a...

you can monitor the overflow tank level for a couple weeks and see if the level drops 1/4 inch or so... Small leaks will take a few weeks to show a drop in level... Also, after shutdown you should...
06-17-2019, 08:35 PM
Replies: 5
Views: 234
Posted By steve(ill)

you said the starter / solenoid "CLICKS" when the...

you said the starter / solenoid "CLICKS" when the key is turned... So WHY are you looking at the fuel pump / alternator / sensors / throttle body ?????????

IT WONT CRANK..... See if you can get...
06-17-2019, 08:20 PM
Replies: 6
Views: 296
Posted By steve(ill)

the small tube the photo is your air vent line ...

the small tube the photo is your air vent line

https://i.ebayimg.com/images/g/qlEAAOSwmOBb7Ukq/s-l1600.jpg
06-17-2019, 08:14 PM
Replies: 6
Views: 296
Posted By steve(ill)

as you put gas in the truck, the AIR needs to get...

as you put gas in the truck, the AIR needs to get out of the tank space... There is a 3/8 hose/ tube that comes off the top of the tank and runs up along the 2 inch fill line, and taps back into the...
06-16-2019, 02:56 PM
Replies: 16
Views: 1,372
Posted By steve(ill)

The recall has CHANGED in the last 3 months.. You...

The recall has CHANGED in the last 3 months.. You get a SOFTWARE upgrade to ALL trucks.. If the truck still continues to have a SHIFT problem, you might get a new LEAD FRAME ( electrical / connector)...
Showing results 1 to 15 of 500
 


 
Forum Jump

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.