Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: quads
Showing results 1 to 15 of 137
Search took 0.36 seconds.
04-22-2004, 08:01 PM
Replies: 13
Views: 20,561
Posted By quads

most garages and deale3rships just drain it into...

most garages and deale3rships just drain it into oil along with tranny and gear fluid the only thing thing that dont get tossed into the oil is antifreeze.
02-08-2003, 09:51 PM
Replies: 3
Views: 641
Posted By quads

Windshield Wipers won't work below 50 f

I have no idea what would casue this really without going through it nmyself...so this is the best I can offer its the chart Ford offers for diagonstic procedures
Godbless quads


Symptom Chart...
02-08-2003, 09:14 PM
Replies: 1
Views: 579
Posted By quads

Ping noise

you could try running higher premium gas that helps it burn smoother but the EGR is probable due to it cools the combustion area and lets the fuel burn more effeicently which is what casues the fuel...
01-28-2003, 09:19 PM
Replies: 3
Views: 343
Posted By quads

electric choke question on 82 F-100

the tube does down to your exhaust manifold to speed up the warming of the choke via the exhaust what Lartry said is good but from what I read I woiuld bank on the choke just being set to rich and...
01-28-2003, 09:14 PM
Replies: 5
Views: 446
Posted By quads

82 300-6 distributor

you can also get a vaccum pump attach it to the centrigal advance pump it up should increase the idle of the truck as it is advanceing the timing when you do that
Godbless
quads
01-28-2003, 09:10 PM
Replies: 9
Views: 548
Posted By quads

Exhaust size

best advise is to emaure it may differ a bit at the dealer where I work I just installed a cat-back exhaust at 2 1/4 stock so thats worth just getting under and measureing it out it was a 93 F-150...
01-28-2003, 08:44 PM
Replies: 14
Views: 766
Posted By quads

My truck is annoying me!!

well its been very cold here as well in the cold its normal to hear different sounds everything just takes longer to get up and going use lithum or red grease to lube everything like latches and...
12-18-2002, 09:33 PM
Replies: 7
Views: 267
Posted By quads

What's the deal with my oil pan gasket?

hey bud try a product called the right stuff ... it's whats Ford is using in conjuction with gaskets...also works well very well Good Luck and Godbless
11-22-2002, 09:57 PM
Replies: 5
Views: 615
Posted By quads

wiper motor?

I have same problem but Im blessed enough to workl at a Ford dealership so i pulled out the serivce manual and the flow chart gives us 3 things that could be the problem
1. the switch on the column...
11-10-2002, 08:04 PM
Replies: 19
Views: 6,298
Posted By quads

93 f-150 brake drum removal

one other way to try it is get a air hammer with a flat hammer and use it around the axle flange on the drum the vibration combined with the hammering usually works well thats one trick we use at the...
Replies: 13
Views: 298
Posted By quads

302 EFI after overhaul

Onething to check is the mass air flow needle inside... if it gets gummed up it wont let the truck idle down... thats the first thing that comes to mind
Godbless Quads
Replies: 11
Views: 390
Posted By quads

4 liters of oil per 5000 km,90 psi compression, how long does it have to live?

buddy I would say not real long reason I say that is each cylinder takes about 90 psi to even fire and if you are close to that point now I would say its starting to be on borrowed time.... sorry for...
Replies: 4
Views: 917
Posted By quads

BATTERY AIN'T GETTING NO CHARGE

you prob got a bad altanator. take it back and exchange it and see what that does or if you can get it to the parts store do that and let them run the tester on it.. thats the best place to start
Replies: 8
Views: 448
Posted By quads

brake q's

Im not sure about that Rod length but do knmow that rod is adjustable you can turn it out to engage the master cylinder but be careful too much length and your rear brakes will drag and that isnt a...
Replies: 2
Views: 366
Posted By quads

80 F250 caliper removal

the calipers actually may be held in place by a sldiing pin... the bolts might just hold the bracket the caliper mounts too look at that and see what ya come up with
Godbless
quads
Showing results 1 to 15 of 137
 


 
Forum Jump

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.