Ford Truck Enthusiasts Forums - Search Results

Notices
Search: Posts Made By: Brews
Showing results 1 to 10 of 10
Search took 0.37 seconds.
10-16-2014, 09:32 PM
Replies: 3
Views: 1,951
Posted By Brews

Brake vacuum booster pump is wearing out. Be...

Brake vacuum booster pump is wearing out. Be careful when you pull away and have to stop if you hear the pump running. After 20 seconds all is good as engine vacuum picks it up.
01-31-2009, 01:30 PM
Replies: 3
Views: 440
Posted By Brews

I'd go with the crankshaft position sensor...

I'd go with the crankshaft position sensor myself. I had one last summer that kept getting towed in and would start right away when I tried it. It finally wouldn't go and monitoring the signals saw...
01-31-2009, 01:14 PM
Replies: 10
Views: 466
Posted By Brews

Is black smoke coming from tailpipe? Could be a...

Is black smoke coming from tailpipe? Could be a sign of a leaking injector. But I'd rather prove out the fuel pressure problem first. Key on engine off pressure should be 40psi as suggested, running...
01-31-2009, 12:59 PM
Replies: 4
Views: 674
Posted By Brews

I'd be going after a bad ignition coil pack. When...

I'd be going after a bad ignition coil pack. When you can't nail the problem down to one cylinder it's sometimes at fault. Have you run a graphical power flow test on it? There are three ignition...
01-31-2009, 12:43 PM
Replies: 9
Views: 668
Posted By Brews

This engine is known for the oil pressure sending...

This engine is known for the oil pressure sending unit sticking cold start. Changed a bunch of them, also same switch on Crown Vic 4.6L, has the same problem. Change out the oil pressure sending unit...
01-30-2009, 11:09 PM
Replies: 14
Views: 480
Posted By Brews

Aftermarket pumps fail...unless you know someone...

Aftermarket pumps fail...unless you know someone racing nascar...they don't even touch the quality standards built into your OEM pump...been there too many times! Waste of time for me to rip apart an...
01-30-2009, 10:44 PM
Replies: 6
460
Views: 453
Posted By Brews

you bought it...burn it! lots of thump for your...

you bought it...burn it! lots of thump for your buck though...bigger the hole you got the more it takes to feed it; only suggestion I got is to check which ratio you got in the rear end-you got the...
01-30-2009, 10:24 PM
Replies: 6
Views: 374
Posted By Brews

4x4 will get you out of situations that most of...

4x4 will get you out of situations that most of us would not of have gotten into! I am not aware of any options allowing the front axle to be locked unless you own an army vehicle; ford hasn't...
01-30-2009, 10:10 PM
Replies: 23
Views: 1,129
Posted By Brews

I agree with sooperdoodle-radius arm bushings;...

I agree with sooperdoodle-radius arm bushings; usually clonk hard when you go through a deep pothole, rattle a bit over bumps; not an easy job at home
01-30-2009, 09:56 PM
Replies: 22
Views: 813
Posted By Brews

Belt squeal spray products ruin the belt almost...

Belt squeal spray products ruin the belt almost immediately and cause other problems like loose tension which makes all the other components run slower...think about it. I doubt your new tensioner is...
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.