Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: Franklin2
Showing results 1 to 15 of 497
Search took 0.57 seconds.
Replies: 11
Views: 342
Posted By Franklin2

Most all the old Fords that I have had did have...

Most all the old Fords that I have had did have some valve train ticking or clacking. I think he is worried about the oil pressure problem, which can be causing the noisy valve train. You are...
Replies: 7
Views: 263
Posted By Franklin2

Most people will find their wiring problems at...

Most people will find their wiring problems at the old brittle connectors with the wore out corroded connections inside. So the way I see it, splicing into that is a effort in futility.

The next...
Replies: 3
Views: 130
Posted By Franklin2

Here's a picture of G710 Look in figure 4 ...

Here's a picture of G710 Look in figure 4

http://www.garysgaragemahal.com/uploads/6/5/8/7/65879365/3350969_orig.jpg
Replies: 3
Views: 130
Posted By Franklin2

That ground wire from the ignition module goes...

That ground wire from the ignition module goes all the way back to the computer on pin 16. Pin 20 on the computer is the computer ground, It comes out, goes through a connector at the right hand...
Replies: 11
Views: 342
Posted By Franklin2

Pulling the oil pan would be a logical next step,...

Pulling the oil pan would be a logical next step, though like you mentioned a big one. You could pull a valve cover and see what it looks like inside. If it's all sludged up you can know this...
Replies: 5
Views: 191
Posted By Franklin2

There are other common places for leaks back...

There are other common places for leaks back there. A leak around the rear of the valve cover. A leak out of the back intake seal. And if you happen to have a oil pressure sensor back there they...
Replies: 5
Views: 191
Posted By Franklin2

Time to pull the trans/transfer case and replace...

Time to pull the trans/transfer case and replace the clutch. If there is oil all over the clutch you will have to fix the leak also.
Replies: 11
Views: 342
Posted By Franklin2

After you bought it did you just change the oil? ...

After you bought it did you just change the oil? If so, the detergents in the new oil could have broken loose some sludge and it has clogged up the pickup to the oil pump.
Replies: 1
Views: 205
Posted By Franklin2

Go for it if you do not want to rebuild the carb...

Go for it if you do not want to rebuild the carb you have. Just make sure you have a new filter screwed into the fuel inlet. You could dump the old filter out on a paper towel and see how much junk...
Replies: 16
Views: 657
Posted By Franklin2

I would not touch the EGR either. Too much risk...

I would not touch the EGR either. Too much risk for pinging. After your trip if you want to strip the entire top of the engine down, put a aftermarket carb on it (It may be easier to also put a...
Replies: 7
Views: 263
Posted By Franklin2

If that wiring company will make a harness that...

If that wiring company will make a harness that plugs into the Ford components, I am all ears, this is something new and hot off the press and something lots of people would be interested in. Keep us...
Replies: 5
Views: 245
Posted By Franklin2

That is another reason to use a small aux fuse...

That is another reason to use a small aux fuse box. There is nothing wrong with going to the parts store and getting a small one off the rack they have hanging there. You can then run one heavy 10...
Replies: 7
Views: 263
Posted By Franklin2

The heads would be a improvement all around. ...

The heads would be a improvement all around. Check the chamber size, they will probably have smaller combustion chambers. This will raise the compression ratio of the engine. So long as you do not...
Replies: 1
Views: 158
Posted By Franklin2

Try this link. Look how the head is up hgher...

Try this link. Look how the head is up hgher above the waterpump boss on each side on the 351w.
...
06-15-2019, 04:28 PM
Replies: 4
Views: 201
Posted By Franklin2

Here's a schematic for your 1970....

Here's a schematic for your 1970. http://fordification.com/tech/wiring/wiring-diagram-70_master.jpg

Here is the wiring number/color/function decoder chart....
Showing results 1 to 15 of 497
 


 
Forum Jump

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.